Hai cercato la traduzione di square with the scale factor of 3 da Spagnolo a Inglese

the n parameter is the scale factor.
the n parameter is the scale factor.

it is not easy to calculate these effects, but the general consensus is that, overall, they magnify the temperature increase by about a factor of 3."
it is not easy to calculate these effects, but the general consensus is that, overall, they magnify the temperature increase by about a factor of 3."

the form of anglicanism in beverley is more on the anglo-catholic side of the scale, represented with the bishop being a member of the society of the holy cross.
the form of anglicanism in beverley is more on the anglo-catholic side of the scale, represented with the bishop being a member of the society of the holy cross.

1 consideremos una 8x8 tablero dividido en 64 unidades plazas. in this board a set of 8 squares with the property that on each of the rows and the columns of the board there is exactly one square of the diagonal . hacemos un llamamiento en diagonal en esta placa un conjunto de 8 plazas con la propiedad de que en cada una de las filas y las columnas de la junta es exactamente un cuadrado de la diagonal. there are exactly two coloured squares.
we call diagonal in this board a set of 8 squares with the property that on each of the rows and the columns of the board there is exactly one square of the diagonal .

except for nozzles located on the underside of a tank bottom that rests directly on the tank grade29 and nozzles with reinforcements that are too narrow to permit compliance with the following provisions, single-thickness reinforcing plates and saddle flanges or integral reinforcing pads on manholes or nozzles attached to the outside of a tank shall be provided with at least one telltale hole with a maximum actual diameter of 3/8 in. that shall be tapped for a preliminary compressed-air and solution-film test for soundness of attachment welds around the manhole or nozzle and its reinforcement both inside and outside the tank. these telltale holes shall be left open when the tank is in service. the surface of the reinforcing plate, saddle flange, or pad adjacent to the tank wall shall be relieved slightly by grinding to be reasonably certain that the test pressure will extend entirely around the nozzle even though the reinforcement may be drawn tightly against the tank wall by the welding.620
6except for nozzles located on the underside of a tank bottom that rests directly on the tank grade29 and nozzles with reinforcements that are too narrow to permit compliance with the following provisions, single-thickness reinforcing plates and saddle flanges or integral reinforcing pads on manholes or nozzles attached to the outside of a tank shall be provided with at least one telltale hole with a maximum actual diameter of 3/8 in. that shall be tapped for a preliminary compressed-air and solution-film test for soundness of attachment welds around the manhole or nozzle and its reinforcement both inside and outside the tank. these telltale holes shall be left open when the tank is in service. the surface of the reinforcing plate, saddle flange, or pad adjacent to the tank wall shall be relieved slightly by grinding to be reasonably certain that the test pressure will extend entirely around the nozzle even though the reinforcement may be drawn tightly against the tank wall by the welding.20