Şunu aradınız:: atomic bombed (İngilizce - Malayca)

atomic mass
pengekstrakan audio digital

atomic-mass
uranium

atomic number
nombor atom

atomic & & nuclear
atom & & nuklear

relative atomic mass
jisim molekular relatif

atomic radius [pm]
boron

gradient: atomic radius
wilmer van der gaast

display atomic mass in the pse
latitud (darjah desimal):

construct, view and analyse atomic structures
bina, papar dan analisis struktur atom

view and manipulate atomic and other chemical systems
lihat dan manipulasi atom dan sistem kimia yang lain

+ new positions atomic amount will be larger.
+ jumlah atomik kedudukan baru akan lebih besar.

%1 is not an atomic type. casting is only possible to atomic types.
qxml

inconel 718 is known as super alloy and it is difficult to cut. it is a widely utilized material for atomic force plant, gas turbine motors, steam turbines, petrochemical gear and aviation furthermore for rocket part due high temperature resistance. other than that, inconel 718 have high corrosion resistance and connected broadly in high temperature utilizes because of its superior properties. however there are still numerous issues that should be connected with inconel 718 because there are also have disadvantage such as reduce tool life and severe surface abuse on machined surface due to its high values of cutting force. welding and adhesion of inconel 718 onto the cutting tool often happen during machining creating extreme surface of machined. in the perspective of manufacturing industries, expanding interest of profitability and quality in machining inconel 718 are the principle challenges keeping in mind the end goal to get the ideal cutting condition and decrease the expense of generation. to investigate the optimum cutting condition for inconel 718, some experiment must be conducted such as full immersion end milling inconel 718. in this research, the cutting force and chatter vibration is greatly influence the wear of cutting tool in machining work. at low cutting speed of machining inconel 718, the cutting force increase but it also depends on the feed rate and depth of cut. besides that, the consumption of lubricant cutting fluid also plays an important role during machining this super alloy. based on this research, we investigate the surface integrity of inconel 718 machined using tialn coated carbide tool by varying radial depth of cut. at the end, optimum cutting conditions were selected in machining operation for further development in manufacturing industries.
the suface integriti inconel 718 dimesin menggunakan tialn bersalut karbida alat dengan mengubah radial depth of cut