您搜索了: asymptotic (英语 - 马耳他语)

asymptotic lc50
asintotika lc50

asymptotic model
mudell asintotiku

asymptotic chamber pressure
pressjoni asimptotika fil-kompartiment

(1) this ci is asymptotic because the exact ci could not be computed
(1) dan is-ci hu asintomatiku għax is-ci preċiż tiegħu ma setgħax jiġi kkalkulat

c2 = pressure switch to be connected to the brake actuator of the trailer , to operate at 75 % of the asymptotic pressure in the brake actuator cf
c2 = switch ta' pressa li se jkun konness mal-attwatur tal-brejk tal-karru, biex jopera għall-75 % tal-pressa asymptotika fl-attwatur tal-brejk cf.

if the curve has reached a plateau, that is, becomes approximately asymptotic to the time axis, the steady-state bcfss is calculated from:
jekk il-kurva laħqet kondizzjoni, jiċifieri, ssir bejn wieħed u ieħor asintotika ma' l-assi tal-ħin, il-kondizzjoni statika tal-bcfss hija kkalkulata minn: c

in the case of the actuation time of 0 72 seconds, the time elapsing between the beginning of actuation of the control pedal and the moment when the pressure in the brake cylinder reaches 75 % of its asymptotic value must not exceed 0 76 seconds.
fil-każ ta’ ħin ta’ attwazzjoni ta’ 0.2 sekondi, il-ħin li jgħaddi bejn il-bidu ta’ l-attwazzjoni tal-pedala ta’ kontroll u l-mument meta l-pressjoni fiċ-ċilindru tal-brejk tilħaq 75 % tal-valur asintotiku ma għandux ikun aktar minn 0.6 sekondi.

the time elapsing between the moment when the pressure produced in the control pipe by the simulator reached 10 % of the asymptotic pressure and the moment when the pressure in the brake cylinder of the trailer reaches 75 % of its asymptotic value must not exceed 0 74 seconds.
il-ħin li jgħaddi bejn il-mument meta l-pressjoni prodotta fil-pajp ta’ kontroll mis-simulatur laħqet 10 % tal-pressjoni asintotika u l-mument meta l-pressjoni fiċ-ċilindru tal-brejk tal-karru tilħaq 75 % tal-valur asintotiku tiegħu ma għandux ikun aktar minn 0.4 sekondi.

the time which elapses between the start of the activation of the control pedal and the moment when the pressure measured at the coupling head of the control pipe reaches × % of its asymptotic value must not exceed the values listed in the table below:
il-ħin li jgħaddi bejn il-bidu ta’ l-attivazzjoni tal-pedala ta’ kontroll u l-mument meta l-pressjoni mkejjla fir-ras ta’ l-igganċjar tal-pajp ta’ kontroll tilħaq x% tal-valur asintotiku ma għandux jaqbeż il-valuri elenkati fit-tabella ta’ hawn taħt: