尝试学会如何从人工翻译例句找到译文。
아래의
从: 机器翻译 建议更好的译文 质量:
来自专业的译者、企业、网页和免费的翻译库。
添加一条翻译
개체 아래의 치수선
dimension line below the object
最后更新: 2014-09-20 使用频率: 1 质量: 参考: Translated.com
(아래의 #2 무시)
(ignore #2 below)
最后更新: 2010-07-18 使用频率: 1 质量: 参考: Translated.com警告:包含不可见的HTML格式
설정값은 <PROTECTED> <PROTECTED> 아래의 <PROTECTED> 화면에 있습니다.
the setting is located in the <PROTECTED> screen under <PROTECTED> <PROTECTED>.
最后更新: 1970-01-01 使用频率: 1 质量: 参考: Translated.com警告:包含不可见的HTML格式
b1에 아래의 수식을 삽입하십시오:
enter the following formula in b1:
最后更新: 2016-10-24 使用频率: 1 质量: 参考: Translated.com
아래의 로고 레이블 스티커를 참조하십시오.
see the logo-label sticker examples below:
最后更新: 1970-01-01 使用频率: 1 质量: 参考: Translated.com
그렇게 하려면 아래의 링크를 클릭하십시오.
to do so, click on the link below:
배터리 칸 내부 또는 배터리 아래의 레이블
on a label inside the battery compartment or underneath the batteries
最后更新: 2011-02-06 使用频率: 4 质量: 参考: Translated.com
지원되는 프로세서 목록은 아래의 표를 참조하십시오.
see the table below for a complete list of supported processors.
最后更新: 1970-01-01 使用频率: 3 质量: 参考: Translated.com
ctrl+` (이 테이블 아래의 노트 참조)
ctrl+` (see note below this table)
最后更新: 2014-10-04 使用频率: 1 质量: 参考: Translated.com
그러면 아래의 그림처럼 선택 표시가 확인란에 나타납니다.
a check mark should appear in the box as in the picture below.
아래의 "기타 운영 체제" 섹션을 참조하십시오.
see also the "other operating systems" section below.
아래의 표에 전면 패널 커넥터의 신호 이름이 나와 있습니다.
the figure below is a connection diagram for the front panel connector.
이러한 상황 중 하나가 발생하면 아래의 절차를 참조하여 복구하십시오.
if one of these scenarios occurs, refer to the appropriate procedure below to recover.
最后更新: 2007-01-15 使用频率: 1 质量: 参考: Translated.com
아래의 표에 설명된 구성이 아닌 경우에는 이 블록에 점퍼를 끼우지 마십시오.
do not place jumpers on this block in any configuration other than the one described in the table below.
아래의 그림 범례에 사용되는 색상이 나와 있습니다(해당하는 경우).
the figure legend below lists the colors used (when applicable).
最后更新: 1970-01-01 使用频率: 2 质量: 参考: Translated.com
hi-<PROTECTED> <PROTECTED> 2.0을 비활성화하려면 아래의 절차를 따르십시오.
follow the steps below to disable hi-<PROTECTED> <PROTECTED> 2.0.
아래의 표에 일반, 구성 및 복구 모드에 대한 점퍼 설정이 나와 있습니다.
the table below describes the jumper settings for the three modes: normal, configure, and recovery.
最后更新: 1970-01-01 使用频率: 4 质量: 参考: Translated.com
아래의 링크는 인텔 웹 사이트 외부로 연결되며 인텔은 해당 웹 사이트의 내용을 관리하지 않습니다.
below is a link that takes you off of the intel web site. intel does not control the content of the destination web site.
마더보드 아래의 효과적인 공간 = 섀시 스탠드오프 높이(그림 2 참조)
effective clearance under the motherboard = chassis standoff height (see figure 2)
프로젝트를 빌드할 디렉터리입니다. 홈 아래의 / src 같은 폴더에 두는 것이 좋습니다.
choose the directory where you will build your project. your home / src is a good default location.
最后更新: 2011-10-23 使用频率: 1 质量: 参考: Translated.com