From professional translators, enterprises, web pages and freely available translation repositories.
idealerweise wird ein druckluftmotor bei seiner nenndrehzahl und dem für die anwendung erforderlichen nenndrehmoment betrieben.
ideally air motors should be operated at nominal speed and at the torque specifically required for the application.
der koeffizient gibt das verhältnis zwischen dem maximalen (anlaufsdrehmoment) und nenndrehmoment der antriebsmaschine an.
the coefficient gives the ratio between the maximum (start-up) and nominal torque of the driving machine.
bei maschinen mit einem großen nenndrehmoment ist der unterschied zwischen den fertigungskosten der ein- und beidseitigen maschinen kleiner.
in machines with a higher torque rating, the difference in the manufacturing cost is smaller between single-sided and double-sided machines.
mit einer nenndrehzahl von 60 1/min bei einem nenndrehmoment von 63,6 nm bewirkt dieser die höhenregulierung der farbwanne.
with a nominal speed rating of 60 rpm and a basic torque of 63.6 nm it adjusts the height of the ink sump.
da das arbeitsdrehmoment unter dem nenndrehmoment liegt, dreht der motor unter geringer last nahe der leerlaufdrehzahl mit 450 umdrehungen/minute.
given that the working torque is less than the nominal torque, the motor runs at close to the no load torque, with 450 rpm, under low demand.
bei der nenndrehzahl erreicht der druckluftmotor seine maximale leistung. mit der formel: nenndrehmoment mal arbeitsdrehzahl (nenndrehzahl) geteilt durch 9550 errechnet man die benötigte theoretische leistung in kw.
with the formula: nominal torque times working speed (nominal speed) divided by 9550 you can find the theoretically required power in kw.
der hiperdrive hda 70 verfügt über die ip-schutzklasse 65 und zeichnet sich durch einen ec-motor mit hoher lebensdauer, ein hohes nenndrehmoment und ein sehr hohes selbsthaltemoment aus.
the hiperdrive hda 70 has ip protection class 65 and an extremely durable ec motor with high torque and very high self-holding torque.
die abdichtung zwischen dem zylinderkopf und dem zylinder ist ferner gewährleistet, wenn die befestigungsmuttern des zylinderkopfes am kalten motor mit 1/3 des vom hersteller vorgeschriebenen nenndrehmoments angezogen sind,
the leak protection between the cylinder head and the cylinder still holds when the cylinder head nuts are cold-tightened at one-third of the nominal torque prescribed by the manufacturer,