From professional translators, enterprises, web pages and freely available translation repositories.
sensitivity depends on the pipe diameter.
Чувствительность зависит от диаметра трубопровода.
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
spudbase, pipe diameter Ø1111mm, wt 15mm
Блок сбора шлама, диам. трубы Ø1111 мм, wt 15 мм
Last Update: 2018-05-07
Usage Frequency: 2
Quality:
outlet pipe diameter (mm) 125×125
Диаметр трубы мм 125×125
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
tail pipe diameter [mm] [not mandatory]
10.1.6.13 Диаметр выхлопной трубы [мм] [не обязательно]
Last Update: 2017-01-02
Usage Frequency: 2
Quality:
4. pipe diameter 70 ... 100 mm - 1 m;
4. Труба диаметром 70 ... 100 мм - 1м;
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
the smaller the entry angle, the larger the pipe diameter.
Чем меньше входной угол, тем больше будет диаметр трубы.
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
pipe diameter up to: 300 mm at a spacing of 2,5 m
диаметр трубы до 300 мм – через каждые 2,5 м
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
for adjusting the height of the print head to the exterior pipe diameter
Для регулирования высоты печатающей головки в зависимости от диаметра трубы
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
for pipe diameter of 35 mm to 80 mm in standard, gmp and atex applications.
Для труб стандартного диаметра от 35 мм до 80 мм, gmp и atex применения.
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
total length of pipeline is 118.2 km with pipe diameter of 720 millimeters.
Общая протяженность нефтепровода составляет 118,2 км, диаметр трубы - 720 миллиметров.
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
all of the system's assemblies are automatically set to the required pipe diameter.
Все конструктивные группы установки автоматически настраиваются на требуемый диаметр трубы.
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
steam entry pipe diameter 250 mm (320) 400 mm (480, 640, 800)
диаметр входа пара 250 мм (320) 400 мм (480, 640, 800)
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
for the calculation, specify the inner and outer pipe diameter and total length of the pipeline.
Для расчета укажите внутренний и внешний диаметр трубы и общую длину трубопровода.
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
minimum pipe temp can be taken as +3°c (based on kalamkas study)
Минимальная температура в трубопроводе - принимается равной - +3°c (по аналогии с месторождением Каламкас).
Last Update: 2013-04-07
Usage Frequency: 1
Quality:
steel pipes show higher pressure losses than pvc pipes. a pipe diameter of 1,8 cm is suitable for flow rates up to
Потери давления в трубах из пластика меньше, чем в трубах из гальванизированной стали.
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
also suitable for small nominal pipe diameters.
Подходит также для небольших диаметров трубы
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
capacity: 1500 l/h at a flow pressure from 2,5 up to 10 bar and a water pipe diameter of 1/2"
производительность: 1500 л/ч при давлении от 2,5 до 10 бар и проходимости воды 1/2“
Last Update: 2018-02-21
Usage Frequency: 1
Quality:
Warning: Contains invisible HTML formatting
ep exhaust pipe with an in-line opacimeter, there must be no change in the exhaust pipe diameter within 3 exhaust pipe diameters before or after the measuring zone.
При использовании установленного в выхлопной трубе дымомера не должно быть никаких изменений в диаметре выхлопной трубы в пределах зоны, равной трем диаметрам выхлопной трубы, до и после зоны измерения.
Last Update: 2017-01-03
Usage Frequency: 1
Quality:
for an isokinetic system, the exhaust pipe must be free of elbows, bends and sudden diameter changes for at least 6 pipe diameters upstream and 3 pipe diameters downstream of the tip of the probe.
Для изокинетической системы выхлопная труба не должна иметь колен, изгибов и резких изменений диаметра на расстоянии, по крайней мере равном шести диаметрам трубы вверх от наконечника пробоотборника и трем диаметрам трубы вниз от него.
Last Update: 2017-01-03
Usage Frequency: 1
Quality:
heating networks’ reconstruction started up in almaty 11 may 2014 energy and utilities management of almaty city started seasonal work on the reconstruction of heating networks at nine sites, pipe diameter from 500 to 1000 mm.
В Алматы начали реконструкцию теплосетей 11 Мая 2014 Управление энергетики и коммунального хозяйства города Алматы приступило к сезонной работе по реконструкции тепловых сетей на девяти участках, диаметром труб от 500 до 1000 мм.
Last Update: 2018-02-21
Usage Frequency: 1
Quality: