Hai cercato la traduzione di currier and ives plates and cups da Spagnolo a Inglese

"currier and ives: a catalogue raisonné".
"currier and ives: a catalogue raisonné".

he was unsatisfied with many of the plates and included additional notes on the plates in the book.
he was unsatisfied with many of the plates and included additional notes on the plates in the book.

the amount of power transferred increases with the frequency and the capacitance between the plates, which is proportional to the area of the smaller plate and (for short distances) inversely proportional to the separation.
the amount of power transferred increases with the frequency and the capacitance between the plates, which is proportional to the area of the smaller plate and (for short distances) inversely proportional to the separation.

a map of chili, patagonia, la plata and ye south part of brasil.
a map of chili, patagonia, la plata and ye south part of brasil.

"histoire générale et iconographie des lépidoptères et des chenilles de l’amérique septentrionale by boisduval and le conte (1829-): original drawings used for the engraved plates and the true identities of four figured taxa".
"histoire générale et iconographie des lépidoptères et des chenilles de l’amérique septentrionale by boisduval and le conte (1829-): original drawings used for the engraved plates and the true identities of four figured taxa".

currier and ives fue una exitosa empresa impresora de estados unidos que operó entre 1834 a 1907, era propiedad de nathaniel currier (1813–1888) y james merritt ives (1824–1895).
currier and ives was a successful american printmaking firm headed by nathaniel currier (1813–1888) and james merritt ives (1824–1895).

bengal 39: 335-376* john,s; joshi b d; soni v c 1993 studies on morphometry, cephalic plates and body scales of ophisops microlepis blanford.
bengal 39: 335-376* john,s; joshi b d; soni v c 1993 studies on morphometry, cephalic plates and body scales of ophisops microlepis blanford.

except for nozzles located on the underside of a tank bottom that rests directly on the tank grade29 and nozzles with reinforcements that are too narrow to permit compliance with the following provisions, single-thickness reinforcing plates and saddle flanges or integral reinforcing pads on manholes or nozzles attached to the outside of a tank shall be provided with at least one telltale hole with a maximum actual diameter of 3/8 in. that shall be tapped for a preliminary compressed-air and solution-film test for soundness of attachment welds around the manhole or nozzle and its reinforcement both inside and outside the tank. these telltale holes shall be left open when the tank is in service. the surface of the reinforcing plate, saddle flange, or pad adjacent to the tank wall shall be relieved slightly by grinding to be reasonably certain that the test pressure will extend entirely around the nozzle even though the reinforcement may be drawn tightly against the tank wall by the welding.620
6except for nozzles located on the underside of a tank bottom that rests directly on the tank grade29 and nozzles with reinforcements that are too narrow to permit compliance with the following provisions, single-thickness reinforcing plates and saddle flanges or integral reinforcing pads on manholes or nozzles attached to the outside of a tank shall be provided with at least one telltale hole with a maximum actual diameter of 3/8 in. that shall be tapped for a preliminary compressed-air and solution-film test for soundness of attachment welds around the manhole or nozzle and its reinforcement both inside and outside the tank. these telltale holes shall be left open when the tank is in service. the surface of the reinforcing plate, saddle flange, or pad adjacent to the tank wall shall be relieved slightly by grinding to be reasonably certain that the test pressure will extend entirely around the nozzle even though the reinforcement may be drawn tightly against the tank wall by the welding.20