전문 번역가, 번역 회사, 웹 페이지 및 자유롭게 사용할 수 있는 번역 저장소 등을 활용합니다.
de proef moet worden genomen op het vlak van het proefstuk dat overeenstemt met het buitenvlak van de gelaagde ruit wanneer deze op het voertuig is gemonteerd, en ook op het binnenvlak indien dit van kunststof is.
the test shall be carried out on that surface of the test piece which represents the outside face of the laminated-glass pane when the latter is mounted on the vehicle and also on the inward face in the case of a glass with a plastic coating.
uitstekende kappen en randen aan koplantaarns zijn toegestaan , mits zij niet meer dan 30 mm uitsteken ten opzichte van het buitenvlak van het koplantaarnglas en hun afrondingsstraal op geen enkel punt minder dan 2,5 mm bedraagt.
projecting visors and rims shall be permitted on headlights, provided that their projection, as measured in relation to the external transparent surface of the headlight does not exceed 30 mm and their radius of curvature is at least 2.5 mm throughout.
beproevingszone b is de zone van het buitenvlak van de voorruit die zich meer dan 25 mm van de zijrand van het doorzichtige oppervlak bevindt en die wordt begrensd door de snijlijn van het buitenvlak van de voorruit met de volgende vier vlakken (figuur 2):
test zone b is the zone on the outer surface of the windscreen situated more than 25 mm from the side edge of the transparent surface and delimited by the intersection of the outer surface of the windscreen with the four following planes (see figure 2):
de zijdelingse bescherming mag de totale breedte van het voertuig niet vergroten en het grootste deel van haar buitenoppervlak mag niet meer dan 120 mm verzonken zijn ten opzichte van het buitenvlak (de maximumbreedte) van het voertuig.
the lateral protective device shall not increase the overall width of the vehicle and the main part of its outer surface shall not be more than 120 mm inboard from the outermost plane (maximum width) of the vehicle.
wanneer de afstand tussen twee opeenvolgende delen gelijk aan of kleiner dan 25 mm is , moeten de afrondingsstralen van de buitenvlakken der delen ten minste 0,5 mm bedragen.
however, if the distance between two consecutive elements is equal to or less than 25 mm, the radii of curvature of external faces of the elements shall not be less than 0 75 mm.