Je was op zoek naar: tension of tubes (Engels - Estisch)

manufacture of tubes
torutootmine

lowest tension of service
madalaim ajutine pinge

15 45 appropriate combination of tubes
15 45 sobiv tuubide kombinatsioon

size of tube
toru suurus

thus, the exhaust split is determined by the total number of tubes.
seega määrab heitgaasi jaotise torude üldarv.

release the tension of the reducer spring before opening the bottle valve.
enne balloonikraani avamist vabastage reduktori vedru pinge alt.

manufacture of tubes, pipes, hollow profiles and related fittings, of steel
terastorude, -õõnesprofiilide jms -toruliitmike tootmine

manufacture of tubes for fluids transport, decoration, structural applications, heat exchangers,
torujuhtmete tootmine, dekoratsioonid, konstruktsioonid, soojusvahetid;

with a surface tension of 36 dyne/cm or more but not more than 39 dyne/cm,
mille pindpinevus on 36–39 dyn/cm,

the described methods are to be applied to the measurement of the surface tension of aqueous solutions.
kirjeldatud meetodid on ette nähtud vesilahuste pindpinevuse mõõtmiseks.

it is used in many applications, including shipbuilding, engineering and the manufacture of tubes and pipes.
seda kasutatakse mitmel otstarbel, sealhulgas laeva- ja masinaehituses ning torude tootmisel.

nace 24.20: manufacture of tubes, pipes, hollow profiles and related fittings, of steel
nace 24.20: terastorude, -õõnesprofiilide jms -toruliitmike tootmine

measured value of the surface tension of the water (mn/m) both at the same temperature.
mõõtmisel leitud vee pindpinevus (mn/m) mõlemad samal temperatuuril.

in nursery a mortality shall be considered abnormal when a sudden sizeable mortality occurs in a short time on a number of tubes.
poegade kasvatusettevõttes peetakse suremust ebatavaliseks juhul, kui äkiline märkimisväärne suremus esineb lühikese aja jooksul mitmes kasvatuskohas.

in the form of tubes or cylindrical solid forms (including forgings) with an outside diameter of more than 75 mm.
torud või silindrikujulised täismaterjalid (sh sepised), mille välisläbimõõt on üle 75 mm.

1a202 composite structures, other than those specified in 1a002, in the form of tubes and having both of the following characteristics:
1a202 komposiitstruktuurid, muud kui punktis 1a002 nimetatud, torude kujul, millel on järgmised omadused:

a set of tubes (multiple tube unit) is installed in the exhaust pipe ep to provide a proportional sample of the raw exhaust gas.
proportsionaalse proovi saamiseks toorest heitgaasist paigaldatakse väljalasketorusse ep torustik (mitmetoruline seadmestik).

leave around 10 cm of tube to close the chain.
umbes 10 cm jäetakse kudumiahela sulgemiseks.

in the form of tubes or cylindrical solid forms (including forgings) with an outside diameter of more than 75 mm.
torud või silindrikujulised täismaterjalid (sh sepised), mille välisläbimõõt on üle 75 mm.

reduce the surface tension of water to 4,5 × 10- 2 n/m (45 dyn/cm) or less.
alandab vee pindpinevust väärtuseni 4,5 × 10-2 n/m ja madalamale.