Je was op zoek naar: completed (Koreaans - Frans)

completed
vous avez terminé ce cours.

not completed
vous n'avez pas encore terminé ce cours.

% 1% percent completed
%1 & #160; %percent completed

오늘 끝남to- do is completed
se finit aujourd'huito-do is completed

기한:% 1to- do completed on datetime
Échéance & #160;: %1to-do completed on datetime

이동( m) delete completed to- dos
déplacer versdelete completed to-dos

진행 중 separator for status like this: overdue, completed
en cours separator for status like this: overdue, completed

대상 폴더@ info: status number of folders for which update is completed.
dossier de destination & #160;: %1@info: status number of folders for which update is completed.

this function sorts an array. elements will be arranged from lowest to highest when this function has completed.
suivant

대상 폴더@ info: status number of folders for which update is completed.
dossier de destination & #160;: %1@info: status number of folders for which update is completed.

즐거운 주말! whether to uppercase the first letter of completed fuzzy time strings above: translate as 1 if yes, 0 if no.
week-end & #160;! whether to uppercase the first letter of completed fuzzy time strings above: translate as 1 if yes, 0 if no.

output using fwrite() is normally buffered at 8k. this means that if there are two processes wanting to write to the same output stream (a file), each is paused after 8k of data to allow the other to write. stream_set_write_buffer() sets the buffering for write operations on the given filepointer stream to buffer bytes. if buffer is 0 then write operations are unbuffered. this ensures that all writes with fwrite() are completed before other processes are allowed to write to that output stream.
cela signifie que si deux processus veulent écrirent dans le même flôt de sortie (par exemple, un fichier), ils font une pause tous les 8ko pour laisser l'autre écrire aussi. stream_set_write_buffer() configure la taille du buffer des opérations d'écritures pour le flôt stream avec la nouvelle valeur de buffer cela signifie que si deux processus veulent écrirent dans le même flôt de sortie (par exemple, un fichier), ils font une pause tous les 8ko pour laisser l'autre écrire aussi. stream_set_write_buffer() configure la taille du buffer des opérations d 'écritures pour le flôt stream avec la nouvelle valeur de buffer octets.