Results for 10k translation from English to Hindi

10k
10 कि

10k followers
10k followers

salary 10k-22k cab meal
salary 10k-22k cab meal

maine khareed tha 10k mai
maine khareed tha 10k mai

ok i do 10k by trusting you
सर्वर का प्रॉब्लम हो रहा फिर भी मैं कोशिश कर रहा

bhai is job me 10k lgane jaruri hai kya
bhai is job me 10k lgane jaruri hai kya

so tell delivery boy that you have only 10k for the clearing of the parcel that you want your parcel to be cleared and delivered to your home with immediate effect. tell him now tell him ok
इसलिए डिलीवरी बॉय को बताएँ कि पार्सल को साफ़ करने के लिए आपके पास सिर्फ़ 10 हज़ार रुपये हैं और आप चाहते हैं कि आपका पार्सल साफ़ हो जाए और तुरंत आपके घर पहुँचा दिया जाए। उसे बताओ अब उसे बताओ ठीक है

googlthe main components of the project are at89c52 microcontroller, ir sensor (ir transmitter and ir receiver) and leds. the basic connections required for 8051 microcontroller involve crystal, reset and external access. in order to use the on-chip oscillator, the 8051 microcontroller requires an external clock. this is provided by a crystal oscillator. an 11.0592mhz quartz crystal is connected to xtal1 and xtal2 pins with two 22pf ceramic capacitors connected to it. the reset circuit of the microcontroller consists of a 10k resistor, 10uf capacitor and a push button. all the connections of the reset circuit are shown in the circuit diagram. external access pin is used to access external memory when it is connected to ground. anyway, we are not going to use any external memory here. so, connect this pin to vcc via a 10k resistor. the next hard ware we are going to connect is the ir receiver. we are going to connect the 8 ir receivers to port 0 pins of the microcontroller. in order to use the port0 as i/o port, we need to connect external pullup resistors to the port 0 pins. after that, connect the output of the ir receiver i.e. anode terminal of the photo diode to port 0 pins. cathode terminals of the photo diodes are connected to supply. also, a 3.3k resistor is connected between the anode terminal and ground. the next part of the circuit is ir transmitter. ir transmitter is not a part of the microcontroller connections as the only job of the ir transmitter is to continuously emit infrared rays. hence, connect the 8 ir transmitters with corresponding 8 current limiting resistors of 470 ohms with a power supply. finally, we need to connect the leds. we need to connect the led’s with the help of transistors to the port2 of the microcontroller. the base of the 8 2n2222 transistors is connected to the port 2 of the microcontroller while the emitters of the transistors are connected to ground. an led along with a series current limiting resistor of 100 ohms is connected to the each of the collector terminal of the transistor.e translet
query length limit excedeed. max allowed query : 500 chars