Usted buscó: elongation (Inglés - Turco)

Inglés

Traductor

elongation

Traductor

Turco

Traductor
Traductor

Traduce al momento textos, documentos y pistas de voz con Lara

¡Traducir ahora!

Contribuciones humanas

De traductores profesionales, empresas, páginas web y repositorios de traducción de libre uso.

Añadir una traducción

Inglés

Turco

Información

Inglés

elongation

Turco

uzama

Última actualización: 2017-02-14
Frecuencia de uso: 1
Calidad:

Inglés

cell elongation

Turco

hücre uzaması

Última actualización: 2013-06-12
Frecuencia de uso: 1
Calidad:

Inglés

uniform elongation

Turco

tekdüze uzama

Última actualización: 2017-02-14
Frecuencia de uso: 1
Calidad:

Inglés

elongation at fracture

Turco

kırılmada uzama

Última actualización: 2017-02-14
Frecuencia de uso: 1
Calidad:

Inglés

elongation at break of aged

Turco

yaşlanmış kopma uzaması

Última actualización: 2016-11-14
Frecuencia de uso: 1
Calidad:

Inglés

elongation at break of non aged

Turco

yaşlanmamış kopma uzaması

Última actualización: 2016-11-14
Frecuencia de uso: 2
Calidad:

Inglés

resistant to shrinkage, elongation and all deformations caused by loads and design actions on the tunnel structure;

Turco

tünel yapısındaki yükler ve tasarım eylemleri nedeniyle oluşan büzülme, uzama ve tüm deformasyonlara dayanıklı olmak;

Última actualización: 2017-12-02
Frecuencia de uso: 1
Calidad:

Inglés

breaking load, elongation and resistance tests shall be completed on the aluminum alloy catenaries conductor in accordance with the requirements of iec61089.

Turco

kopma yükü, uzama ve direnç testleri, iec61089 gereksinimleri doğrultusunda aluminyum alaşım katener iletkeni üzerinde tamamlanacaktır.

Última actualización: 2016-11-13
Frecuencia de uso: 1
Calidad:

Inglés

the minimum tensile strength shall not be less than 14.5 mpa. and the minimum elongation at break shall be 200%.

Turco

minimum çekme dayanımı 14.5 mpa'dan daha az olmayacak ve kopma anındaki minimum uza % 200 olacaktır.

Última actualización: 2016-11-13
Frecuencia de uso: 1
Calidad:

Inglés

tensile test (tensile strength, lower yield stress and elongation) (bs en 10002-1:

Turco

Çekme deneyi (Çekme dayanımı, alt akma gerilimi ve uzama) (bs en 10002-1:

Última actualización: 2017-01-16
Frecuencia de uso: 1
Calidad:

Inglés

 sometimes, due to the very low stiffness of the supporting springs and the large value of the lift coefficient, elongation of the supporting system came to its maximum before the critical wind speed was reached.

Turco

 bazen, mesnet yaylarının çok düşük sertliği ve büyük kaldırma katsayısından dolayı mesnet sisteminin uzaması, kritik rüzgar hızına ulaşılmadan önce maksimum değere ulaşmıştır.

Última actualización: 2017-01-15
Frecuencia de uso: 1
Calidad:

Inglés

the mechanical strength and other mechanical properties such as tensile strength, minimum elongation at break and physical/chemical properties shall also conform to the relevant clauses in iec 60502.

Turco

Çekme dayanımı, minimum kopma anındaki uzama ve fiziksel/kimyasla özellikler gibi mekanik dayanım ve diğer mekanik özellikler iec 60502 standardının ilgili maddelerine de uyacaktır.

Última actualización: 2016-11-13
Frecuencia de uso: 1
Calidad:

Inglés

it has been shown that 7sk rna, a metazoan ncrna, acts as a negative regulator of the rna polymerase ii elongation factor p-tefb, and that this activity is influenced by stress response pathways.

Turco

7sk rna adlı bir metazoan ncrna türü, rna polimeraz ii uzama faktörü p-tefb'nin bir negatif düzenleyicisi olarak etki ettiği ve bu etkinliğin stres tepki yolağı ("stress response pathway") tarafından etkilendiği gösterilmiştir.

Última actualización: 2016-03-03
Frecuencia de uso: 1
Calidad:

Advertencia: contiene formato HTML invisible

Inglés

however, rope manufacturers give only the rope’s impact force "f0" and its static and dynamic elongations that are measured under standard uiaa fall conditions: a fall height "h0" of 2 x 2.3 m with an available rope length "l0" = 2.6m leads to a fall factor "f0" = "h0/l0" = 1.77 and a fall velocity "v0" = ("2gh0")1/2 = 9.5 m/s at the end of falling the distance "h0".

Turco

ancak, halat üreticileri sadece halat etkisine güç vermek için "f0" ve statik ve dinamik uzamaları standart altında ölçülür olduğunu uiaa esneme koşulları: düşme yüksekliği "h0" of 2 x 2.3m kullanılabilir halat uzunluğu ile "l0" = 2.6m esneme faktörüne yol açar "f0" = "h0/l0" = 1.77 ve düşme hızı "v0" = ("2gh0")1/2 = 9.5m/sn sonunda düşme mesafesi "h0".

Última actualización: 2016-03-03
Frecuencia de uso: 1
Calidad:

Advertencia: contiene formato HTML invisible

Obtenga una traducción de calidad con
10,199,013,108 contribuciones humanas

Usuarios que están solicitando ayuda en este momento:



Utilizamos cookies para mejorar nuestros servicios. Al continuar navegando está aceptando su uso. Más información. De acuerdo