Imparare a tradurre dagli esempi di traduzione forniti da contributi umani.
Da: Traduzione automatica
Suggerisci una traduzione migliore
Qualità:
Da traduttori professionisti, imprese, pagine web e archivi di traduzione disponibili gratuitamente al pubblico.
oil inlet port
6 размеров входе выходе:
Ultimo aggiornamento 2013-09-23
Frequenza di utilizzo: 1
Qualità:
Riferimento:
induction port, inlet port, intake port
впускной канал
Ultimo aggiornamento 2014-12-01
Frequenza di utilizzo: 1
Qualità:
Riferimento:
the product is conveyed into the tank through the inlet port in the lower part of side surface.
Вход продукта в бак осуществляется с помощью патрубка, находящегося в нижней части ёмкости.
Ultimo aggiornamento 2018-02-21
Frequenza di utilizzo: 1
Qualità:
Riferimento:
the piston, when in the position at top dead centre, shall not cover the inlet port.
8.24.5.1.3 Поршень: в верхней мертвой точке поршень не должен закрывать впускное отверстие.
Ultimo aggiornamento 2017-01-03
Frequenza di utilizzo: 1
Qualità:
Riferimento:
the piston: the piston, when in the position at top dead centre, shall not cover the inlet port.
5.1.3 Поршень: в верхней мертвой точке поршень не должен закрывать впускное отверстие.
Ultimo aggiornamento 2016-12-04
Frequenza di utilizzo: 1
Qualità:
Riferimento:
(c) the piston, when in the position at top dead centre, shall not cover the inlet port.
c) Поршень: в верхней мертвой точке поршень не должен закрывать впускное отверстие.
Ultimo aggiornamento 2016-12-04
Frequenza di utilizzo: 1
Qualità:
Riferimento:
this provision does not apply to those parts of the transfer port coincident with the inlet port in the case of vehicles, the engine of which is equipped with an induction system incorporating reed valve(s).
Это положение не распространяется на те части пропускного окна, которые совпадают с впускным отверстием, в случае транспортных средств, двигатели которых оборудованы системой всасывания с пружинным(и) клапаном(ами).
Ultimo aggiornamento 2017-01-03
Frequenza di utilizzo: 1
Qualità:
Riferimento:
the large 19 mm (0.75") material inlet ports permit flow rates of 4 to 5 gallons per minute, depending on pump capability and material viscosity.
Большие впускные отверстия на 19 мм (0,75 дюйма) позволяют получить показатели расхода потока от 4 до 5 галлонов в минуту в зависимости от мощности насоса и вязкости материала.
Ultimo aggiornamento 2018-02-21
Frequenza di utilizzo: 1
Qualità:
Riferimento:
Attenzione: contiene formattazione HTML nascosta