Van professionele vertalers, bedrijven, webpagina's en gratis beschikbare vertaalbronnen.
screw off
tertanggal bila berpeluh
Laatste Update: 2017-01-11
Gebruiksfrequentie: 1
Kwaliteit:
Referentie:
screw liner
pelapik
Laatste Update: 2019-02-13
Gebruiksfrequentie: 1
Kwaliteit:
Referentie:
tighten the screw
kelip
Laatste Update: 2020-06-03
Gebruiksfrequentie: 1
Kwaliteit:
Referentie:
do not screw the wall
mesti kemas bilik selepas main
Laatste Update: 2019-07-16
Gebruiksfrequentie: 1
Kwaliteit:
Referentie:
i’ll screw ur life up
maksud membolehkan bermula dari yang baru
Laatste Update: 2021-09-27
Gebruiksfrequentie: 1
Kwaliteit:
Referentie:
the front bumper on the left side of the screw is removed
bumper depan (driver side) skru tercabut
Laatste Update: 2020-01-17
Gebruiksfrequentie: 1
Kwaliteit:
Referentie:
the rear cabin handle has been loosened and ripped off and has been changed with a new 3 x screw
please changes to another date on the 19th & 20th dec 22
Laatste Update: 2022-12-16
Gebruiksfrequentie: 1
Kwaliteit:
Referentie:
Waarschuwing: Bevat onzichtbare HTML-opmaak
leaving the screw loose, using the hole at one end, secure the beam to the moment chuck on the backboard
meninggalkan skru longgar, menggunakan lubang di satu hujung selamat rasuk untuk membuang masa di papan belakang
Laatste Update: 2021-12-20
Gebruiksfrequentie: 1
Kwaliteit:
Referentie:
adhesive wear adhesive wear occurs when two metals rub together with sufficient force to cause the removal of material from the less wear resistant surface. if the two metals have a comparable chemical analysis and hardness, a galling action can occur where one metal is actually welded to the other causing high and low spots where material is added or removed. the screw and barrel can come into contact with each other during operation. the screw is cantilevered in the barrel and is supported only at its shank and by the plastic in the barrel. when conditions cause excessive contact between the two components, adhesive wear and/or galling will occur on the screw flight od and the barrel wall. there are several causes of adhesive wear and galling, all of which can be prevented through the proper design, manufacture and use of the machinery components.
kejuruteraan mekanik