Обучается переводу с помощью примеров, переведенных людьми.
Добавлены профессиональными переводчиками и компаниями и на основе веб-страниц и открытых баз переводов.
trek een selectie zoals op de print:
make a selection like this:
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
en haal de print eruit.
and get out the pcb.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
de maat van de print aanpassen
· adjust the size of the board
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
daarna kunt u de print starten.
after this, you can start printing.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
op de meest links hoek van de print zie je de spanningsconnector.
on the most left corner of the pcb you can see a power-connector.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
opmerking: de print-out is 'as is'.
note: the print-out is 'as is'.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
dit zou de print stijl bewerker moeten testen
this should test the contact print style editor widget
Последнее обновление: 2014-10-08
Частота использования: 1
Качество:
de print wordt daarna aangebracht op de drager.
the print is then affixed on the carrier.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
print:/(de hoofdmap van de print kio-slave)
print: / (ie; the root of print-kioslave)
Последнее обновление: 2014-10-14
Частота использования: 4
Качество:
nu de print bijna klaar is, volgt de afwerking.
since the pcb is now almost ready, there still is some post processing which has to be done now.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
deze zijn pin-compatible en kunnen zonder aanpassingen op de print worden gezet.
the 2sk135 are from magnatec. luckily, good replacements are available in the form of the buz900 and buz905, also from magnatec. these are pin-compatible and can be used on the board without any adaptions.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
de volgende aansluitingen zijn gemaakt naar de print van de diskdrive:
the following connections are made to the pcb of the drive:
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
het instellen van de print service was veel lastiger dan ik had gedacht.
setting up the print service was much tougher than i had thought.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
in deze dac zijn voor het voeden van de print in totaal drie voedingsmodules gebruikt.
in this dac, a total of three supply-modules are used to feed the pcb. one of them supplies a stabilized 9v for the 3.3 and 5v connection, and the other two supply +/-15v for the opamps.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
dit alles is geheel op de print van de speler opgebouwd, gebruik makend van de originele lay-out.
all of this is entirely built on the pcb of the player, by using the original lay-out.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
de voedingsmodules zijn aan weerszijde van de print geplaatst, dicht bij de overeenkomende aansluitingen.
the supply modules have been placed on each side of the pcb, close to their corresponding connections.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
grote verschil tussen de dtv en de dtv2 is dat de dtv2 pal en ntsc kan doen door een paar onderdelen op de print te wijzigen.
main difference between the dtv and the dtv2 is that the dtv2 can do pal and ntsc by replacing some parts on the pcb.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
problemen ten gevolge van de verkeerde verwerkingstemperatuur bij het lamineren of versneld drogen van de print.
problems as a result of incorrect processing temperature during the laminating or accelerated drying of the print.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
deze documenten welk worden voornamelijk benoemd want reviseren op de scherm van computer luisteren mee, veeleer dan voor de print-out.
these are documents which are intended mainly for viewing on the screen of the computer monitor, instead of for listing.
Последнее обновление: 2018-02-13
Частота использования: 1
Качество:
bovendien zullen de print-out van het nieuwe systeem veel eenvoudiger af te lezen zijn dan de huidige.
moreover, the outputs of the new system, i.e. the printouts, will be much easier to interpret than the existing ones.
Последнее обновление: 2012-02-29
Частота использования: 3
Качество: