Şunu aradınız:: holes (İngilizce - Xhosa)

holes
imigubasi

%1 holes
% 1 imingxuma

number of holes
inani lemingxuma:

holes may have to be enlarged.
iminyaka ingandiswa.

two holes are then bored on these lines.
imingxunya emibini ngoko igrunjiwe/ibhorelwe kule migca.

when this had set, the limber holes were plugged.
xa oku kusethule, imingxunya evetye-vetye yavalwa.

hawse hole stoppers that completely close the holes.
izimiso zomngxuma ezivala gingci imingxuma.

this is done by passing stop pins through holes in both.
le yenziwa ngokugqitha indawo ekuma isiqhobosho ngaphaya komngxunya kumacala.

next, bore corresponding holes into but not through the timbers.
enye, grumba imingxunya emeleneyo kuyo, kodwa hayi ngamaplanga.

this is secured by six shoulder screws in a choice of holes.
le ikhuselwe ngesithandathu samagxa isikrufu sokukhetha imingxunya.

holes cut in the bulwarks of a ship to enable water to drain overboard.
yimingxuma esikwe kwisikhuselo esijikeleze inqanawa ngaphezulu ukwenzela ukuba amanzi aphumele ngaphandle enqanaweni.

but any holes thus made will have to be patched and made good again before refloating.
kodwa nayiphina imingxunya eyenziwayo ujakufuneka ivalwe yenziwe ilunge kwakhona phambi kokuba iphinde idadiswe.

now bore holes in the stiffener, the planking, the copper tingle and the doublers.
ngoku grumba imingxunya kwiziqiniswa, emgangathweni weplanga, umntlontlozo wesinyithi kunye neziphindaphindi.

all parts should be well lubricated and the oil-holes clear of paint and dirt.
zonke iinxenye kufuneka zithanjiswe kakuhle kwakunye namafutha imingxuma icacise ipeyinti nobumdaka.

hole radius (1)
umngxunya welayini esuka embindini wesangqa eya kumda wesangqa (1)