Réalisées par des traducteurs professionnels, des entreprises, des pages web ou traductions disponibles gratuitement.
en temperaturgivare placeras strax före volymmätningsanordningen.
there must be a mixing chamber in which the vehicle exhaust gases and the dilution air are mixed so as to produce a homogeneous mixture at the chamber outlet. the homogeneity of the mixture in any cross-section at the location of the sampling probe must not vary by more than ± 2 % from the average of the values obtained at at least five points located at equal intervals on the diameter of the gas stream.
temperaturgivare skall placeras i den del av lagerutrymmet där temperaturen är högst,
the temperature sensor of the reader must be situated in the area where the temperature in the hold is the highest;
temperaturen i kammaren registreras vid två punkter av temperaturgivare som anslutits för att visa ett medelvärde.
the temperature in the chamber is recorded at two points by temperature sensors which are connected so as to show a mean value.
om ett instrument med en temperaturgivare av kontakttyp används ska värmeledande pasta anbringas mellan ytan och givaren så att tillfredsställande termisk kontakt säkerställs.
if an instrument with a contact temperature sensor is used, heat-conductive paste shall be applied between the surface and the sensor to ensure adequate thermal contact.
om ett instrument med en temperaturgivare av kontakttyp används skall värmeledande pasta anbringas mellan ytan och givaren så att tillfredsställande termisk kontakt säkerställs.
if an instrument with a contact temperature sensor is used, heat-conductive paste shall be applied between the surface and the sensor to ensure adequate thermal contact.
en temperaturgivare (t1) (noggrannhet och precision ± 1 k) ansluten vid en punkt omedelbart före volymmätningsanordningen.
a temperature censor (t) (accuracy and precision ± 1 k), fitted at a point immediately before the volume measurement device;